Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Banning, CA
Gate installation in Banning has to account for one thing above all else: the San Gorgonio Pass wind corridor. A gate that goes up plumb and square on a calm morning can be fighting sustained westerlies by afternoon, and that changes how we spec posts, hinges, operators, and hardware from day one. Ontario Gate Company has served Banning since 2011, and we specialize exclusively in gates. If you’re planning a new driveway gate, an entry gate for an HOA community, or replacing a wind-beaten gate that’s finally given up, call (855) 707-3634 and we’ll walk the site with you before anything gets ordered.
Why Banning Homes Are Different
Banning’s housing stock splits into two rough categories, and each one fails differently. The older mid-century homes near downtown and up on the Banning Bench tend to have original 20-plus-year-old gate hardware: steel posts set shallow, hinges that were undersized from the start, and swing gates that have been torqued out of alignment by thousands of gust cycles. Out in Sun Lakes and the other 55+ and HOA-governed planned communities, the gates are mostly uniform stucco-and-wrought-iron or vinyl, but they’re aging too, and many communities run multiple entry gates that all see the same wind load. The hot, dry summers bake wood gates until they warp and pull at their fasteners, and the Santa Ana events in fall can hit a gate with the kind of sustained pressure that strips hinge plates and burns out operator motors. In the Pass wind corridor, we regularly see swing gates that were plumb when installed but have been torqued out of alignment and stripped at the hinge plate by years of daily gusts: a failure mode rare in calmer inland cities. Banning gate work is not a set-it-and-forget-it job. It’s a constant re-tensioning and reinforcement cycle, and the right installation has to anticipate that from the first hole dug.
Styles & brands we work with
Our Main Banning Services
Most calls we get from Banning fall into two buckets: a gate that won’t open or close reliably, and an electric or automatic gate that’s dead, intermittent, or unsafe. Here’s what each involves in this wind corridor.
Gate Repair in Banning
Mechanical gate repair out here is dominated by wind-fatigue failures: bent frames, sheared hinges, sagging swing gates, and posts that have loosened in the soil. We remove the gate, re-set and reinforce the posts, re-hang with heavier hardware where the design allows, and re-tension everything so the gate actually rests where it should. For full details on what we fix and what it costs, see Gate Repair in Banning.
Electric Gate Repair in Banning
Electric gate repair in Banning is its own specialty because the wind pushes operators past their rated duty cycle far faster than the manufacturer intended. We diagnose on-site: control boards, limit switches, safety sensors, loop detectors, and motors. When an operator has been repeatedly blown out, we look at whether a heavier-duty unit or a different mounting strategy makes more sense than another same-model swap. Learn more at Electric Gate Repair in Banning.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Banning
Gate installation in Banning starts with the wind load calculation, not the gate style. A swing gate with a solid panel acts like a sail, and in the San Gorgonio Pass that means the post embedment depth, hinge rating, and operator size all get bumped up from what a calmer city would call standard. We install automatic gates, driveway gates, sliding gates, and electric gate systems across the 92220 ZIP, and we’re trained on Viking, Ghost Controls, DoorKing, and Elite equipment, among others. Every installation begins with a free on-site measure and a written price agreed before any work starts. For the full scope of what a new system involves, see Gate Installation.
Automatic Gate Installation
Signs you need it
A gate that requires getting out of the car to open and close it manually, or an existing automatic gate that has failed beyond economical repair, is the usual starting point.
What it costs in Banning
Automatic gate installation in Banning typically runs $8,500 to $18,000 for a complete system with operator, safety devices, and access controls.
How we do it
We size the operator to the gate’s actual wind exposure and duty cycle, set and brace the posts, mount the operator, and install and test the safety edges and photo eyes before wiring in keypads or remotes.
Driveway Gate Installation
Signs you need it
A driveway without a gate when a new home is purchased, or a rotted, sagging, or wind-warped gate that no longer closes square, are the clearest signals.
What it costs in Banning
Driveway gate installation in Banning typically runs $6,500 to $16,000 depending on width, material, and automation level.
How we do it
We measure the driveway width and slope, recommend a swing or slide configuration based on available set-back, pour and set the posts deep, hang and align the gate, and install any requested automation.
What Gate Installation Costs in Banning
| Item | Typical range in Banning |
|---|---|
| Driveway gate installation | $6,500 – $16,000 |
| Automatic gate installation | $8,500 – $18,000 |
| Sliding gate installation | $9,000 – $20,000 |
Do you handle the power run and safety edges?
Yes. We handle the full electrical scope for Banning automatic gate installations: the power run to the operator, photo eyes or contact edges, keypads, and any required access control wiring. It is not a split-contractor job.
How long does installation take in Banning?
Most residential Banning gate installations are scheduled over two to three days once equipment arrives. Post-setting and concrete cure time are the long poles, not the gate work itself. Call (855) 707-3634 for a schedule estimate.
Brands We Service in Banning
We stock Banning-specific parts for Viking, Ghost Controls, DoorKing, and Elite operators, which means we’re not chasing down a control board from a distributor while your gate sits open. If we don’t have the part on the truck, we source it from our brands network quickly. Most operator swaps are handled same-visit once diagnosed.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Banning, CA
| Service | Typical range in Banning |
|---|---|
| Gate repair (mechanical) | $180 – $520 |
| Electric gate repair | $220 – $650 |
| Control board replacement | $450 – $1,100 |
| Operator replacement | $1,400 – $4,500 |
| Safety sensor repair | $180 – $450 |
| Driveway gate installation | $6,500 – $16,000 |
| Automatic gate installation | $8,500 – $18,000 |
| Sliding gate installation | $9,000 – $20,000 |
In Banning specifically, wind exposure pushes prices toward the upper end of these ranges: posts need deeper embedment, hinges get upsized, and operators get selected for duty cycle rather than entry price. Every quote is written after an on-site look, and the price is agreed before any work starts. Call (855) 707-3634 for a free estimate.
Neighborhoods We Serve in Banning
We work across Banning’s full 92220 ZIP, from the older grid near downtown to the Bench and the planned communities out toward the pass. We schedule by area and usually reach most Banning addresses within a day or two for non-emergency work.
- Sun Lakes
- Banning Bench
- Downtown Banning
- The Preserve
- Hargrave and Sunset corridor
Service Area – Cities Near Banning
Beyond Banning, we cover the pass and its edges: Cabazon, CA to the east, Calimesa, CA to the west, Yucaipa, CA up the hill, and Valle Vista, CA in between. If you’re in one of those areas, the same wind-driven gate problems apply, just in slightly varied degrees. Call (855) 707-3634 and we’ll confirm the schedule.
Serving Banning, CA — Our Local Coverage Area
We’re based in the Banning area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Banning
For an emergency where a gate is stuck open or won’t secure, we prioritize Banning calls and can often route a technician the same day or next morning. Non-emergency installation and repair visits are typically scheduled within a few days. Call (855) 707-3634 and we’ll give you a straight answer on timing.
Most Banning HOA-governed communities, including Sun Lakes and similar planned neighborhoods, require design review before any gate change. We work with the specs your HOA or community manager provides, and we can install to match existing community look and hardware standards.
We cover all of Banning’s 92220 ZIP, plus the surrounding pass communities: Cabazon, Calimesa, Yucaipa, and Valle Vista. We’re based in Ontario and specialize exclusively in gates, not fencing or general contracting, so every trip to Banning carries gate-specific parts and equipment.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Banning Customers Say
"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Allen Nguyen"Repair is holding. He was quite a bit later than the window I was given, and the office didn't call me about it, I had to call them. The work itself was done well once he got here."
— Beatriz Salazar"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
— Alma Garcia