Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Montclair, CA
Gate installation in Montclair means working with 1950s and 1960s tract homes where driveway gates hang from block walls, not freestanding posts. The job usually involves replacing or upgrading a steel or wrought-iron gate while keeping the original masonry anchor intact, or re-anchoring where the wall itself has shifted. Ontario Gate Company has served Montclair since 2011, and we know what these older walls and clay soils do to gate hardware. Call (855) 707-3634 for a free estimate on a new gate or electric operator.
Why Montclair Homes Are Different
Montclair is one of the few Inland Empire cities where most driveways sit behind a shared, developer-installed block-wall and side-yard gate system. That changes the job. Instead of swapping in off-the-shelf hardware, we’re often matching a 1950s or 1970s steel swing gate to the masonry walls it’s mounted on. The posts on many older tracts near the 10 freeway were set directly into the block rather than poured as separate footings, so when a gate sags, the repair is usually in the wall anchor, not the hinge.
The climate works against gate hardware all year. Hot, dry summers warp wooden gates and dry out hinge grease until pins seize. Santa Ana wind events in fall stress the hinge side of any gate that faces the wind, and winter rains expose rust on older steel frames and loosen the anchors that hold metal gates to block walls. Postwar single-story homes and small apartment courts dominate the 91763 zip code, and many still carry their original gate hardware, which was built well but is now decades into its service life.
Styles & brands we work with
Our Main Montclair Services
Two calls dominate in Montclair: mechanical gate repair on older swing gates, and electric gate repair on the operators that open them. Both are covered below with links to their dedicated Montclair pages.
Gate Repair in Montclair
Gate repair in Montclair typically involves sagging steel frames, seized hinges, rusted weld points, and block-wall anchors that have pulled loose from shifting clay soil. We bring a welder and the stock to re-anchor, straighten, and reinforce rather than forcing a replacement. The local condition that changes the work is the wall: many original gates are still solid, but the anchor point in the block has failed. See the full scope at Gate Repair in Montclair.
Electric Gate Repair in Montclair
Electric gate repair in Montclair runs from dead motors to loop detectors, safety sensors, and control boards. Heat and Santa Ana dust get into operators that were installed two owners ago, and the original wiring on older tracts wasn’t always run in conduit. Our technicians carry control boards, sensors, and receiver parts for the operators we service, so most diagnoses become repairs in the same visit. Full details at Electric Gate Repair in Montclair.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Montclair
Installing a new gate in Montclair usually means one of two scenarios. A homeowner wants to replace a 1950s or 1960s steel gate that’s still standing but becoming more weld than original metal, and they want the new gate anchored properly to the existing block wall. Or an owner is adding a gate to a side yard that never had one, which means cutting into block wall or pouring fresh footings in soil that expands and contracts with the seasons. We handle both, and we handle the electric operator, the safety loop, and the keypad at the same appointment. Our Gate Installation service covers the full scope, from layout through the final safety check.
Automatic Gate Installation
Signs you need it
You’re opening and closing a gate by hand dozens of times a week, or a manual gate is getting left open because it’s easier than getting out of the car.
What it costs in Montclair
An automatic operator alone typically runs $1,200 to $3,500, while a full automatic gate with a steel frame and operator lands from $3,500 to $8,500.
How we do it
We measure the driveway width and travel, choose an operator matched to the gate’s weight and duty cycle, mount the operator to a reinforced post or wall anchor, set travel limits, and wire in safety loops and a keypad.
Driveway Gate Installation
Signs you need it
The existing driveway gate is rusted through at the frame corners or the hinges have torn out of the block wall and been re-welded more than once.
What it costs in Montclair
A new driveway gate in Montclair generally ranges from $1,800 to $6,500, with custom steel running higher than stock options.
How we do it
We match the new gate’s dimensions to the driveway opening, select a paint or powder coat suited to Montclair’s sun and Santa Ana dust, install new hinges with reinforced anchors into the block wall, and adjust the swing or slide to clear grade.
What Gate Installation Costs in Montclair
| Item | Typical range in Montclair |
|---|---|
| Manual gate, basic steel | $1,200 – $3,000 |
| Driveway gate, steel or aluminum | $1,800 – $6,500 |
| Automatic gate with operator | $3,500 – $8,500 |
What pushes a Montclair installation toward the upper end: heavy custom steel, a commercial-grade slide operator, fresh concrete footings where none exist, and conduit runs from the panel to the gate. A block wall anchor that needs rebuilding adds labor but almost always costs less than replacing the wall itself. We quote the full number before any work starts, and that price is the price.
How long does a gate installation take in Montclair?
Most residential installations are done in one day, including the gate, the operator, and the safety loop. Custom steel gates with powder coat add a week or two for fabrication. We confirm the timeline when we quote, not after.
Do I need a permit to install a gate in Montclair?
Setback and height requirements vary by property, so we check the current City of Montclair requirements before finalizing a design. Most one-for-one replacements on existing walls are straightforward. We confirm permits or exemptions as part of the written quote, so there’s no surprise at install time.
Brands We Service in Montclair
We service and stock parts for BFT, Linear, Viking, and Ghost Controls operators, among others. Because our techs work on these systems every week, we can diagnose a board issue or a limit-switch failure on the first visit instead of swapping parts until one works. See our brands for the full list of operators we support.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Montclair, CA
| Service | Typical range in Montclair |
|---|---|
| Gate repair, minor hinge or latch | $75 – $200 |
| Gate repair, weld and re-anchor | $250 – $800 |
| Operator-and-gate repair, full service | $250 – $850 |
| Electric gate repair, standard service | $125 – $500 |
| Electric gate repair, after-hours or emergency | $250 – $1,000+ |
| Manual gate, basic steel | $1,200 – $3,000 |
| Driveway gate, steel or aluminum | $1,800 – $6,500 |
| Automatic operator only | $1,200 – $3,500 |
| Automatic gate with operator | $3,500 – $8,500 |
In Montclair, the main price drivers are older block-wall anchors that need rebuilding, rusted frames that require welding time, and operators that have to be completely rewired because the original run wasn’t in conduit. Emergency calls carry a premium for after-hours dispatch. Every job gets an upfront number, agreed before work starts, with no open-ended hourly billing.
Neighborhoods We Serve in Montclair
We cover the full 91763 zip code, from the tracts near the 10 freeway up to the neighborhoods along Ramona Avenue and Monte Vista Avenue. Our trucks stage out of Ontario, so response times run short across Montclair.
- Central Montclair
- North Montclair
- Ramona Avenue corridor
- Monte Vista area
- Tracts near the 10 freeway
Service Area – Cities Near Montclair
Beyond Montclair, we work the neighboring communities in the western Inland Empire. That includes Claremont, CA to the northwest, Ontario, CA where our shop is based, Upland, CA to the northeast, and La Verne, CA just across the county line. If you’re a few minutes outside Montclair, call and we’ll tell you if we cover your street.
Serving Montclair, CA — Our Local Coverage Area
We’re based in the Montclair area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Montclair
Most Montclair calls are reached the same day during the work week. We stage out of Ontario, roughly fifteen minutes from most of 91763. For a gate that’s stuck open or won’t close, call (855) 707-3634 and we’ll give you an arrival window, not a mystery range.
Yes. Many Montclair subdivisions have design rules for driveway gates, including height, color, and setback. We check your HOA’s written requirements before ordering materials, and we keep the gate within the approved design so you don’t get a violation letter two weeks later.
We repair and replace gates regardless of who did the original install. Many Montclair gates were built decades ago by companies that no longer exist, so we reverse-engineer the hardware and match the repair to the wall condition rather than starting over.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Montclair Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Nabil Karam"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Allen Nguyen"Repair is holding. He was quite a bit later than the window I was given, and the office didn't call me about it, I had to call them. The work itself was done well once he got here."
— Beatriz Salazar