Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Gate Repair Across San Bernardino
Gate repair in San Bernardino usually comes down to one of two things: a footing that has shifted in the sandy decomposed-granite soil, or hardware that has given out after years of inland heat and Santa Ana winds. Most driveway and side-yard gate repairs here run $180 – $400 for hinge, latch, and realignment work, and a full post reset with new concrete typically lands between $350 and $700. We’re Ontario Gate Company, and we specialize exclusively in gates: swing gates, slide gates, electric operators, and the posts and hinges that hold them. If your gate is dragging, leaning, or refusing to open, call (855) 707-3634 and we’ll get a technician out to your San Bernardino property, diagnose the problem on-site, and quote the fix before any work begins.
Why Ontario Gate Company Is San Bernardino’s Preferred Gate Repair Company
We work on gates all over San Bernardino, from the mid-century tract neighborhoods north of Highland Avenue down to older west-side blocks near downtown. Our technicians know these properties: the wrought-iron driveway gates that have been swinging since the 1950s, the block-wall side yards where a swing gate barely clears the fence line, and the shared driveways where vehicle access can’t stop for a day while concrete cures. Because we only work on gates, our vans carry gate-specific parts: hinge barrels, latch strikes, operator control boards, safety photocells, and post-mount hardware for the brands we service. That inventory means fewer return trips and faster completion for San Bernardino homeowners.
Noel Carrasco leads our team, and he’s built the company around a single trade: gates. Not fences with gates as an afterthought, not general handyman work. Every call we take is a gate problem, and every technician we send has been trained on the operator brands and hardware that show up on San Bernardino properties. When a homeowner calls about a Viking slide gate that won’t close or a Ghost Controls swing arm that’s lost its limit, the person who answers already knows what system you’re describing and the common failure points to check first.
Styles & brands we work with
Iron Gate Repair in San Bernardino
Iron Gate Repair in San Bernardino is rarely just about the iron itself; it’s about the post the iron hangs from. On the city’s older west-side and downtown blocks, hinge posts set in decomposed-granite and sandy alluvial soil lean over time, and once the post leans a few degrees, the gate leaf gets heavy on the latch side and starts dragging across the driveway. Our iron gate repairs in San Bernardino cover everything from cutting out and replacing rusted hinge barrels, re-welding cracked pickets and bottom rails, straightening a sagging leaf, and resetting the post so the gate swings true again. A typical hinge and realignment job runs $180 – $320, while post resets with new concrete run $350 – $700 depending on post size and how much of the old footing has to be broken out.
Post Reset and Footing Work
Most iron gate failures we see in San Bernardino trace back to the footing, not the iron. The heat doesn’t help: summer days above 95°F expand the metal, and when the post has shifted in sandy soil, that expansion translates into a gate that binds at the latch in the afternoon and swings free in the morning. We pull the post, check the old concrete for cracks and root intrusion, and pour a new footing deep enough to hold against the seasonal swell.
Weld and Rust Repair
Wrought-iron gates on San Bernardino’s mid-century homes have decades of exposure to dry heat and hard water irrigation overspray. That combination rusts hinge barrels from the inside out and cracks welds at stress points. We grind out the failed welds, re-weld with proper penetration, and treat exposed steel before repainting so the repair holds longer than a quick patch job.
Sliding Gate Repair in San Bernardino
Sliding Gate Repair in San Bernardino usually means working on a cantilever or V-track slide gate on a home where a swing gate simply won’t fit: a short driveway, a steep approach, or a property line tight against the street. These gates ride on rollers and a track, and when the track shifts in the local sandy soil, the gate starts to shudder, jump the track, or stall halfway through its travel. Our slide gate repairs in San Bernardino include track realignment, roller and guide replacement, motor and control board service, and operator limit adjustments that keep the gate from slamming into the end stop. Typical track and roller repair runs $250 – $500; motor or control board replacement on a slide operator runs $450 – $900 installed depending on the brand.
Track Realignment and Roller Replacement
A slide gate that grinds or stalls is usually fighting a track that has settled or a roller that has flattened. On San Bernardino lots with decomposed-granite soil, the track support pads sink unevenly, which pitches the gate and puts side load on the roller bearings. We reset the track on compacted base, shim it level, and replace worn rollers so the gate rolls without strain on the motor.
Operator and Limit Adjustment
Slide gate operators in San Bernardino take a beating from the long dry season: dust works into the limit switches, heat stresses the control board relays, and Santa Ana wind gusts push the gate harder than the stop is designed to absorb. We test the full travel, verify the safety edges and photocells, and set the limits so the gate stops fully open and fully closed without overloading the motor.
Trusted Brands We Service in San Bernardino
If your San Bernardino gate runs on Viking, Ghost Controls, DoorKing, Elite, or any of the other major operator brands, we arrive knowing the equipment. Our techs are trained on the failure patterns specific to each manufacturer: the limit switch drift on older Viking swing arms, the control board quirks on Ghost Controls units, the loop detector sensitivity on DoorKing slide operators. We stock common boards, remotes, safety photocells, and rollers for these systems, which means a San Bernardino repair often finishes in one visit instead of two. That brand-specific knowledge is the difference between a tech who has to open the manual and one who has already fixed the same fault twice this month.
See the difference
Before
After
Before
After
Before
AfterCommon Gate Repair Problems We See in San Bernardino Homes
- Hinge posts leaning in decomposed-granite soil: On the west side and near downtown, posts set decades ago in sandy alluvial soil creep out of plumb and the gate leaf drags on the driveway. This is a footing problem, not a hinge problem, and it will not stay fixed until the post is reset and re-concreted.
- Rusted and seized hardware on aging wrought-iron gates: San Bernardino’s mid-century homes have iron gates that predate modern coatings. Decades of dry heat and irrigation overspray rust hinge barrels from the inside, and the first sign is a gate that groans when it moves and leaves rust dust on the concrete.
- Operator limit drift on automatic gates: When a gate post shifts slightly, the operator’s travel limits no longer match the physical gate position, so the gate slams, reverses, or refuses to fully close. This is common on LiftMaster and Elite operators on San Bernardino properties where seasonal soil movement is steady and cumulative.
- Slide gates binding on settled tracks: On tight lots and shared driveways where a swing gate cannot fit, slide gates carry the load. When the track settles unevenly in local soil, the gate shudders, jumps the rollers, and eventually stalls the motor. Track reset and compaction solves the root cause; simply forcing the gate back onto the rollers does not.
Pricing for Gate Repair in San Bernardino, CA
Gate repair in San Bernardino typically runs $180 – $400 for hinge, latch, and alignment work; $250 – $500 for slide gate track and roller service; $350 – $700 for a full post reset with new concrete; and $450 – $900 for electric operator repair or replacement, depending on the brand and whether a new control board, motor, or remote receiver is required. The two factors that push a San Bernardino repair toward the high end are footing work (the decomposed-granite soil often means digging deeper and pouring a larger pad than a coastal lot would need) and brand-specific operator parts, which we keep in stock for Viking, Ghost Controls, DoorKing, Elite, and others. Every repair is diagnosed on-site, the price is quoted and agreed before any work starts, and we will not add line items to the invoice after the fact. Call (855) 707-3634 for a free estimate.
We Also Serve Cities Near San Bernardino
Our Gate Repair team covers San Bernardino and the surrounding Inland Empire communities, including Muscoy, Highland, Loma Linda, and Rialto. If you’re in one of those nearby cities or anywhere around San Bernardino and your gate is dragging, stalling, or refusing to close, the same crew and the same stocked parts van will reach you. Call (855) 707-3634 and tell us what the gate is doing.
Serving San Bernardino, CA — Our Local Coverage Area
We’re based in the San Bernardino area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in San Bernardino
Because the problem is almost never the hinges. In San Bernardino’s decomposed-granite and sandy alluvial soil, hinge posts lean and settle over time, especially on older west-side and downtown lots where the original footings were poured shallow. Adjusting the hinges might clear the drag for a week, but the gate settles again. The permanent fix is pulling the post, re-setting it plumb, and pouring a new concrete footing deep enough to hold. Call (855) 707-3634 and we’ll confirm whether the post has moved.
Yes. On short driveways, steep approaches, and properties where a swing gate would hit a shared wall or block the sidewalk, a cantilever or V-track slide gate is the standard retrofit. San Bernardino has a lot of these sites: mid-century tract lots with tight setbacks and shared driveways where there is no room to swing a leaf open. We install and service slide systems with proper track bed preparation so the local soil doesn’t settle the track and bind the gate.
Yes, your LiftMaster operator, like any automatic gate system in California, must have functional safety photo-eyes and an operational safety edge or reverse mechanism. California follows UL 325 for automated gate safety, and a gate that closes on a vehicle or pedestrian without working safety devices is a legal and injury liability. We test and replace photocells, safety edges, and loop detectors as part of every automatic gate repair. Call (855) 707-3634 to schedule a safety check.
They will put more stress on it than a gate on the coast, yes. The dry heat shrinks the wood, loosens hinge screws, and warps panels, and then Santa Ana wind gusts push the gate hard against the latch and frame. But a properly built wood gate with a diagonal brace, sealed ends, and hinges lagged into solid framing holds up for years. We repair and reinforce wood side-yard gates in San Bernardino to withstand the seasonal wind cycle instead of just re-hanging them.
On a typical San Bernardino job where we reset a hinge post, the gate swings again the same day on temporary support, and we place the permanent load on the new concrete only after it has cured to working strength. For driveway gates, we schedule the work so a vehicle can still get in and out each evening, and on shared driveways we coordinate with the neighboring access so nobody is blocked. If there’s a pedestrian side gate, we put it on a temporary latch until the post is solid.
If your gate in San Bernardino is leaning, dragging, stalling, or refusing to open, call Ontario Gate Company at (855) 707-3634. We’ll diagnose the problem on-site, quote the repair before any work starts, and get your gate back in operation.
Written by Noel Carrasco, Owner at Ontario Gate Company, providing gate repair in San Bernardino.